Leather Restoration Question from Mark Wiseman
Submitted on 20/04/2013
DIY Could you quote me to repair my drivers seat base as it has wear, and a small hole (due to wear) just above the piping at the door side. Also the seat base has a few scratches (only 2 that I am particularly concerned about) on the upwards face, centre rear of the base. The car is based in Flitwick, Bedfordshire and has covered approx. 115k miles. As it's not too bad I was considering DIY but would appreciate a quote as I am a little reluctant to risk DIY.Thanks, Mark. Model: Range Rover 2002 on
Thank you for you question.
After looking at your photos and getting a second opinion, we think the base bolster needs the attention of Trimmer, Click here for our recommendations. Our methods (connollising) may not last because f the hole and this being a high wear area.
I wouldn't suggest DIY unless your completely confident and have had previous experience.
I would think the rest of what you need doing can be Connollised, call us if you want to book the Range Rover in.
Can We Help You?
"We can offer specialist advice on the best car service to suit your requirements"
When bringing your car to New Again, we often ask you to explain exactly the reason for having your car Protected, Valeted or Repaired. Once we understand exactly what it is you are trying to achieve, we will appraise your vehicle using our detailed appraisal check-sheet allowing us to identify areas of concern and tailor specific services that match your requirements and budget.
If you are not sure what service you need and would like to speak to one of our technicians, simply request a callback by filling in the form on our contact page.