Dwell Time

A dwell time is the time a product needs to be left on a car. Some paint cleaners have a chemical element to them which needs time to work, while some sealants need time to harden and bond to the paintwork after they flash off. This is especially the case with ceramic coatings, which if left to dwell too long can spoil. This gives us a 'window' of time in which to operate. This window can be greatly effected by humidity, temperature and air movement, so on a hot dry day the window is fairly short.

What it means

Dwell time is simply how long you let a product sit on the surface and do its work before you interfere with it. With pre-wash, wheel cleaners, fallout removers, traffic film removers, APCs and even some polishes and coatings, you apply the product and then allow a set amount of time for it to soften dirt, break down contamination or start bonding. After the correct dwell time you then agitate if needed and rinse or wipe away.

Why it matters

• Gives products time to work: Many cleaners and decontamination products need a few minutes of contact to loosen traffic film, brake dust, iron fallout or bug splatter properly.
• Reduces the need for aggression: Allowing enough dwell time means you can use gentler tools and less scrubbing, which helps avoid wash-marring and scratches.
• Protects sensitive surfaces: Over-dwelling strong chemicals, especially in warm sun, can stain, etch or dry out paint, plastics and trims, so timing and conditions matter.
• Ensures coatings cure correctly: For some sealants and coatings, the specified dwell or flash time before wipe-off is part of how the product levels and bonds to the surface.

Where you’ll see it

You will see dwell time mentioned on product labels and data sheets, and in valeting and detailing guides. Instructions may say allow 3–5 minutes dwell, do not allow to dry on the surface or observe recommended flash/dwell time before wiping. It is especially common on pre-wash products, traffic film removers, wheel cleaners, fallout removers, panel wipes and ceramic coatings.

Context

Dwell time sits alongside dilution, agitation and rinse method as part of using chemicals safely and effectively. The ideal dwell time depends on product strength, temperature, humidity and how dirty the car is. In hot sun you may need shorter dwell times or to keep panels wet to prevent drying. In cooler, overcast conditions you may be able to allow the full recommended time. Professional detailers pay close attention to dwell time as it can be the difference between a safe, effective clean and either under-performing products or unnecessary damage.

Common mistakes

• Rinsing cleaners off almost immediately so they never have enough dwell time to break down heavy soiling, then compensating with harsh scrubbing.
• Leaving strong products to dwell too long, or letting them dry on paint and glass in hot sun, which can cause streaking, staining or etching.
• Using the same dwell time in all weathers instead of shortening it on hot panels and lengthening it slightly in cooler, overcast conditions.
• Ignoring manufacturer guidance on dwell or flash times for coatings and sealants, leading to high spots, smearing or poor bonding.

Written by Danny Argent. Last updated 21/11/2025 16:13