- Home
- Knowledge Base
- Glossary
- Autoglym Super Resin Polish
Autoglym Super Resin Polish
Quick answer: Autoglym Super Resin Polish (SRP) is a hand-friendly "all-in-one" cleaner polish that lightly abrades, fills/hides fine swirls with resins, and leaves a short-term protective layer. It's ideal for quick enhancement, not a substitute for machine correction or ceramic.
Super Resin Polish is a superb combination product and one we have recommended for many years. It is easy to buff off, is fairly clean (it doesn't create a lot of dust), it's readily available and it achieves good results. It is a polish suitable for removing oxidation and the more you work it, the more it polishes. It's a diminishing polish, meaning that as you work it, the abrasives break down becoming finer, even when applied by hand.
As it contains fillers, it can hide wash marks, and the durability is pretty good at around six months. All-in-all, it's a very good alternative to both traditional waxes and polishes such as T-Cut.
However, it isn't a suitable topper for ceramic or graphene coatings.
What it means
SRP combines mild abrasives with resinous fillers and a sealant component. By hand or DA on a soft pad, it refines light oxidation and haze, visually masks micro-marring, and leaves a glossy, slick finish with limited durability. It's commonly used as a fast spruce-up or pre-sale tidy, and can be topped with a wax or modern spray sealant for longer-lasting behaviour.
Why it matters
Speed and forgiveness are what keep this product in so many garages. It works by hand, which most correction products do not, and it carries little risk on thin or older clear coats where a machine and a compound would be a gamble. On a daily driver that combination hides wash swirls and brightens the finish without committing anybody to full correction.
It also sits comfortably inside a routine, going under waxes and sealants without argument and reapplying whenever it suits. What matters is knowing what it does: it fills and refines rather than permanently removing anything. Deeper defects are still there afterwards, hidden rather than gone, which is perfectly fine so long as that was the expectation.
Where it gets used
DIY kits, trade valeting, pre-sale detailing, and "quick enhancement" packages where time is tight and heavy correction isn't required.
Context
This entry collects the claims that come up most often at handover: what a polish can and cannot fix, what an all-in-one product is really doing, and where enhancement ends and correction begins. Each has its own entry, and this is the page that ties them together.
How to use
- Prep: wash, decontaminate (iron/tar), optional light clay. Dry thoroughly.
- Apply: thin coat by hand applicator (or soft finishing pad on low DA speed). Work a small section until the film turns uniform.
- Haze & remove: allow a short haze, then buff with a clean microfibre.
- Top: for longer life, add a wax or spray sealant after SRP.
Common mistakes
- Expecting permanent correction: SRP fills many fine marks; deeper defects need machine polishing.
- Over-applying (thick coats) leading to stubborn buff-off and smearing.
- Using it over ceramic coatings; it contains abrasives and synthetic wax and is not a suitable topper.
- Applying on hot panels or direct sun, which can cause rapid haze and difficult removal.
- Using on matte/satin finishes or textured trims, which may gloss or stain unevenly.